Home > Knowledge > Content
Product Categories

inspection steps before using the Abrasive cutting disc

Abrasive cutting disc manufacturers introduce you to the inspection steps before using the Abrasive cutting disc

Abrasive cutting disc manufacturer reminds everyone to do the inspection work before using the Abrasive cutting disc to avoid affecting the work efficiency and product quality. Let's take a look at the inspection steps before work.

1) Check the outer casing of the machine, the outer casing must not be damaged; check the Abrasive cutting disc and use the Abrasive cutting disc to be intact. Inspection method: Observe the Abrasive cutting disc without any gap or crack.

2) Check that the protective cover of the Abrasive cutting disc should be in good condition; check the cable and the plug should not be damaged; run the power for 1 minute to check whether the rotating parts of the tool are flexible and unobstructed.

3) Before turning on the power, check if the power supply voltage meets the requirements and the switch is in the OFF position.

Although these inspection steps seem to be very simple, you must check carefully, not only can reduce a lot of unnecessary trouble, but more importantly, can extend the life of the machine.


Services & Products
diamond saw blade
vacuum brazed diamond products
carbide brazed products
tct saw blade
garden tools
abrasive products
Contact Us
Tel: +86-511-85891166
Fax: +86-511-85119766
Add: NO.66 Runxing Road Runzhou District, Zhenjiang City,
Jiangsu Province china
Email: richoice@richoice.cn
Feedback